HOME HELP FEEDBACK SUBSCRIPTIONS ARCHIVE SEARCH TABLE OF CONTENTS		QUICK SEARCH:   [advanced] Author: Keyword(s): Year:  Vol:  Page:

This Article Figures Only Full Text Free Full Text (PDF) Free Alert me when this article is cited Alert me if a correction is posted Services Similar articles in this journal Similar articles in ISI Web of Science Alert me to new issues of the journal Download to citation manager Citing Articles Citing Articles via HighWire Citing Articles via ISI Web of Science (3) Citing Articles via Google Scholar Google Scholar Articles by Persson, M. Articles by Flyhammar, P. Search for Related Content PubMed Articles by Persson, M. Articles by Flyhammar, P. GeoRef GeoRef Citation Agricola Articles by Persson, M. Articles by Flyhammar, P. Related Collections Time Domain Reflectometry, TDR Soil Physics

SPECIAL SECTION: HYDROGEOPHYSICS

Time-Domain Reflectometry Probe for Water Content and Electrical Conductivity Measurements in Saline Porous Media

^a Department of Engineering Geology, Lund University, Box 118, 221 00 Lund, Sweden
^b Swedish Geotechnical Institute, Hospitalsgatan 16A, 211 33 Malmö, Sweden
^* Corresponding author (magnus.persson{at}tvrl.lth.se)

Received 30 March 2004.

A new coated time-domain reflectometry (TDR) probe design is described and evaluated. In contrast to previous coated TDR probes, our probe may be used to measure both the dielectric constant (K_a) and bulk electrical conductivity (_a) in saline porous media. This was made possible by attaching two coaxial cables to a 0.27-m three-rod probe with a coated central rod. The shield of the first cable was connected to one of the outer rods and the conductor was connected to the coated central rod. The conductor and shield of the other coaxial cable were connected to each of the two outer rods, respectively. Thus, our probe consists of two unbalanced, two-rod probes. The probe is called coated–uncoated probe (CUP). Four prototypes with two different coating materials (i.e., polyolefin and kynar heat-shrink tubes) were evaluated. The probes were calibrated in several fluids having different K_a and _a. The K_a measurement of the coated part of the probe was successfully fitted to target K_a using a two-phase dielectric mixing model. Due to signal attenuation, measurements of K_a were not possible for _a higher than 9 dS m^–1 for the polyolefin-coated probes whereas the upper limits for the kynar-coated probes and the uncoated probe were 5 and 2.5 dS m^–1, respectively. Measurements of _a are only possible with the uncoated part. Measurements of K_a and _a were also taken during three upward infiltration experiments in sand using soil solution electrical conductivities of 0.01, 6.31, and 12.03 dS m^–1. For the uncoated part, K_a could not be measured when _a was higher than about 2 dS m^–1, whereas K_a measurements were possible using the coated part even when _a was 3 dS m^–1.

Abbreviations: CUP, coated–uncoated probe • TDR, time-domain reflectometry

This article has been cited by other articles:

				H. Vereecken, S. Hubbard, A. Binley, and T. Ferre Hydrogeophysics: An Introduction from the Guest Editors Vadose Zone J., November 1, 2004; 3(4): 1060 - 1062. [Full Text] [PDF]